|
|
e.g. 98 camaro intakes
(Not 1998 camaro intakes)
|
|
|
|
|
|
Follow us on
|
| | |
|
Professional installation is strongly recommended for all our products. We are not
responsible for improper installations by non-professionals. Please retain your original
parts and equipments until you fully test our products for proper operations (in case you need to
return the products back for exchange or warranty service).
|
Most of our products do NOT come with
installation guide due to the fact that they are only intended for
professional installer. We are not licensed mechanics and we only offer
limited technical advices. Please seek professional assistance for all
installation of our products. The lack of installation guide is not a
valid reason for a full refund.
|
You may connect the Halo/Angel Eye light rings and/or other decorative LED lights on the lighting products to any 12V power source. Or you may not connect them so that they would remain disabled. Connect the red or white wires to the positive electrode of any 12V power source (e.g. park, signal, day-time running, low/high/fog-beam, side marker lights, etc.) and connect the black wire to the negative/ground electrode of the corresponding power source.
|
|
FACT: MOISTURE IS NOT WATER LEAKING!!!
Cause of Moisture on the Internal Side of Lens
- Temperature difference between the internal side of lens (cooler) and the internal of the lamp (hotter).
- Humidity of the internal of the lamp has to exceed a certain level
Formation of Moisture on the Internal Side of Lens
- When the lamp turned on, temperature inside the lamp would increase and moisture absorbed by the lamp material would be released. This would make hot and humid air inside the lamp.
- Cold weather or other reason decrease the temperature of the lens.
- Once the hot and humid air inside the lamp touches the cooler lens, the hot and humid air would turn into moisture on the internal side of lens.
Remark:
After newly installed lamp turned on for the first time, there might be moisture on the internal side of lens for 1-3 days, depending on the owner's location. This is a normal phenomenon and it should be over after the moisture is released. If the phenomenon continues, then fitness of the lamp should be checked to make sure no extra moisture would enter the internal of the lamp (e.g. the sockets and the covers).
|
| |
| | |
|
|
|